Hi, I currently use the stereo aux in to route my monitor mix through my Kemper (then run out the headphone jack to my IEM transmitter). This means I only use one channel on the FOH board while keeping guitar in stereo in my ears.
Is there any way that I can keep this setup AND add a mono effect loop for a Digitech Freqout I have on the way? For example, using the XLR return jack? I've never used the Kemper effects loop; my apologies if this has been covered previously.
Thanks for your time.
Using stereo aux in and mono effects loop at the same time?
-
patvalley -
April 21, 2017 at 2:37 AM -
Thread is marked as Resolved.
-
-
Hi, I currently use the stereo aux in to route my monitor mix through my Kemper (then run out the headphone jack to my IEM transmitter). This means I only use one channel on the FOH board while keeping guitar in stereo in my ears.
Is there any way that I can keep this setup AND add a mono effect loop for a Digitech Freqout I have on the way? For example, using the XLR return jack? I've never used the Kemper effects loop; my apologies if this has been covered previously.
Thanks for your time.No, this is not possible, because you're running out of inputs. Best would be to put the Freqout (I'm having one on order, too) before the Profiler.
-
Cool, thanks for your response. I was hoping to use the FX loop to avoid running power and cables up to my pedalboard (just a Remote and expression pedal), but I'll try to figure out a good plan.