Just updated rig manager 2.0.15 (12801)and profiler OS 5.1.1.12825. Copied and pasted a patch from patch 1 to patch 2 on a performance in Rig Manager, and a message on profiler says 0% complete and just stays like that.
Changes to Performances in Rig Manager 2.0.15 don't save on Profiler
-
Stierage -
February 24, 2017 at 2:24 PM -
Thread is marked as Resolved.
-
-
Exact same problem! Further, the message stays on the Profiler and never updates, in essence freezing the Profiler. Oddly, the Remote continues to function properly and I can change slots and sounds.
The only way I've found to clear the Profiler is to re-boot. Changes I was attempting to make have been saved.
-
I found that I can clear the message by turning the chicken knob to off and then back on again before it gets chance to shutdown, or by shutting down Rig Manager. Of course you lose your save.
-
same problem ....
-
I'm having this too... setting up performances for songs on tour.. very frustrating
-
same here...rig manager says "updating firmware" which causes Profiler freeze
Preferences "check for updates" not flagged...
sucks...