Kemper with Rocktron All Access - problems with changing sound in one preset

SteffenFritz · October 4, 2016 at 9:29 AM

Hi there,

I´m using my Kemper with a Rocktron All Access in the Browser-Mode, normally without any problems. But sometimes, by playing a preset, the Stomp-Section (for example a tube-sreamer or a compressor) is getting out of the signal, without pressing any button!? This is not always a problem, but sometimes this could happen 5-6 times in a song. By pressing the Preset on the All Access the Stomp-Section works again.

Thanks for any solution,

Steffen

spazmatron · October 5, 2016 at 10:32 PM

Make sure there isn't a conflict with the same midi cc its easy to do scroll through all of the settings for that bank

michaelmellner · October 6, 2016 at 12:46 PM

Hi Steffen...there won't be any suitable help if you don't give us more details like the FW used and so on.

I use the all access since the beginning and had non issue whatsoever so far. This fact makes me still use it in every occasion, comprised pro events.

awaiting some of your infos

Soloist74 · December 15, 2016 at 9:35 AM

Quote from SteffenFritz

I´m using my Kemper with a Rocktron All Access in the Browser-Mode, normally without any problems. But sometimes, by playing a preset, the Stomp-Section (for example a tube-sreamer or a compressor) is getting out of the signal, without pressing any button!?

Just to confirm... are you saying some stomps go off without you touching the All Access?

spazmatron · December 15, 2016 at 3:26 PM

Have you tried resetting your rocktron to factory settings you probably have a midi conflict. If you notice randomness try using this I had issues with weird midi signals with long cable runs and this cleared it up.
http://www.zzounds.com/item--MSLQUADT…hPDxoCGWnw_wcB=