Need a good "Toaster" stand for live use

JerEvil · June 30, 2015 at 10:28 PM

Hey all, I am looking for a foot stand that will securely hold my KPA during live gigs.

Saw this guy and it looked pretty cool

http://www.sweetwater.com/store/detail/Autolocator

but it not sure what else is out there so I am open to suggestions.

Booyah · July 1, 2015 at 7:51 PM

That's the ne I used and lved it, used t put my monitor in front of it and keep it set as low as possible t protect it from drunks lol.

JerEvil · July 2, 2015 at 5:55 AM

Quote from Booyah

That's the ne I used and lved it, used t put my monitor in front of it and keep it set as low as possible t protect it from drunks lol.

Nice! Did it collapse to a small enough size for transport? Also, did the KPA feel "safe enough" on there? For the gigs I play there is no chance of anyone but me knocking it over.

tntent · July 8, 2015 at 9:26 PM

Have a look at a quicklok bs 625 cheap and durable. Search the forum for mine and other member posts on it. Also able to hold my Frfr dxr10 when desired

JerEvil · July 17, 2015 at 8:27 PM

Quote from tntent

Have a look at a quicklok bs 625 cheap and durable. Search the forum for mine and other member posts on it. Also able to hold my Frfr dxr10 when desired

So I got the stand in my OP. Great for the studio bet not sure it is convenient for live use . on your BS625, do you have any issue with accessing the input jack of your cab?

tntent · July 18, 2015 at 5:10 AM

Quote from JerEvil

So I got the stand in my OP. Great for the studio bet not sure it is convenient for live use . on your BS625, do you have any issue with accessing the input jack of your cab?

nope. Though not to sure which Jack your concerned about. It's a bit tight on the back of the Dxr when in the stand if using a regular ts cable. I roll the speaker forward to plug it in.. Live I usually seperate the monitor

Jesone · July 29, 2015 at 1:48 AM

Can you get a CLR cab on the top of the 625?

tntent · July 29, 2015 at 9:55 PM

Quote from Jesone

Can you get a CLR cab on the top of the 625?

I put the kemper on top and speaker on bottom. Sadly I don't own a Clr but I think this would work fine but Check measurements on quicklok website to be safe.

Section8 · September 1, 2015 at 2:16 AM

I got a lift-off case for my 12" powered monitor and use the lid as a table/stand for my 6u rack. You could get a similar setup to put your toaster on.