Kemper not remembering midi settings

JerEvil · May 3, 2015 at 6:42 AM

So for some reason the Kemper is not holding the midi change numbers I am assigning to rigs. It's driving me nuts. Seems to ONLY happen when I have a gig!

anyone else ever had this issue?

JerEvil · May 4, 2015 at 7:33 AM

So no one else has experienced this?

Kempermaniac · May 4, 2015 at 10:48 AM

It only happens when you have a gig? Strange. Maybe it has something to do with your floorboard. Check Midi channels as well as if the two units work in the same range (0-127 vs. 1-128).

Kempermaniac · May 4, 2015 at 1:43 PM

And there was an issue with the Omni mode (can't remember exactly), so check FW.

Booyah · May 4, 2015 at 6:06 PM

Yes 3.0 had an Omni issue, have to set it to channel 2 to get it to work. This was fixed with 3.0.2 however.

JerEvil · May 4, 2015 at 6:56 PM

Ok so set the Kemper to Midi Channel 2 as well as the floorboard? I will give that a try.