Signal chain - Is it possible ?

Chgros · November 10, 2014 at 2:56 PM

Hello
I have the power rack version.
Is there a way to split the signal in two signals having

- Full processed signal stack on one output
- only the effects processed before the amp section in another output.

For exemple

- One output with the full processed signal on one input
- one output with Only the DI guitar affected by transpose

Thank you.

Chgros · November 12, 2014 at 3:17 PM

no one ?

grorig · November 12, 2014 at 4:12 PM

Put the FX LOOP in a slot, that's after the effect(s) you want, and before the AMP section. Use the SEND ( "DIRECT OUT") as your 2nd output.
Go to the FX LOOP menu and adjust the "MIX" level to "0" (zero). You can use the "LEVEL" (into the same menu) to balance the levels between the MAIN and 2nd output to your taste.

Chgros · November 13, 2014 at 8:48 PM

I will try this, thank you !!