Connect Kemper via focusrite isa one when recording

EmirBrandic · July 6, 2014 at 7:17 AM

Hello guys

I have read a lot about connecting a preamp into the signal chain when profiling but my question is if it is ok in the recording stage

I just Bought a focusrite isa one and with this preamp you can record DI and also send a signal to the amp. So i was thinking then maybe I could send it to kemper

So from My guitar i would go to DI input on isa one, from Amp in isa one to kemper and then to audio interface

So my question is is this possible and Will the signal be to strong when reaching kemper? I dont want to destroy my lovely kemper

Thanks

//Emir

Michael_dk · July 6, 2014 at 11:46 AM

You can get the DI directly from the Kemper without going through the ISA one. Check out the chapter on Reamping in the REFERENCE manual.

EmirBrandic · July 6, 2014 at 4:41 PM

s/pdif is not working on my interface (firebox) so unfortunately i cannot use that signal

Michael_dk · July 6, 2014 at 6:21 PM

So use the analogue connections.

EmirBrandic · July 6, 2014 at 8:55 PM

Hello

I just did that. Everything works perfectly except one thing

The input and output indicators are flashing when i feed the return but i get no sound back to the computer

Should i do something with the tracks in my daw which is cubase by the way

Thank you for the help
Appriciate it

EmirBrandic · July 7, 2014 at 6:31 PM

Come on i need help with this
There should be an complete explanation in the manual

Michael_dk · July 7, 2014 at 9:27 PM

Make sure your routing is setup correctly, and make sure your DAW is set to record from the correct source (which will not be the same as your "previous" recording).

Also make sure any interface software you have is correctly setup. Recheck interface connections.