Ahoi there...
Alright, I'll try to keep this short and precise.
The other day I set up my Zoomg 9.2tt to control my KPA via it.
Works like a charm, as far as rig changing and toggling on and
off FX with it goes, except for some things I haven't found info
about neither in the G9 not the KPA manual.
Okay, here comes the main question.
Is it possible to adjust the min/max values of certain parameters, when
they are being controlled via MidiCC-Messages? For example the amp
gain setting? By default, I'll have the amp at minimum drive at the min
pedal position, and the drive to the max at maximum pedal input, when
I use an expression pedal to control it.
But what if I'd like to have the gain at lets say 45% when the pedal is
fully up and at 70% when the pedal is fully depressed?
Same goes for things like Volume Pedal settings, Delay Mix, Reverb, etc...
I'd simply want to be able to make 'em work only in defined ranges,
instead of having the pedal control ALL the way inbetween their
minimum/maximum capabilities.
In both my old Zoom G9 and my Line6 Vetta I can set the range in within
the full pedal way is active within the units themselves. In the KPA, I still
have to find these options yet.
No idea how these handle the stuff internally, or if it's even Midi that contols
stuff like that. Could be another brand specific protocol.
To cut a long story short...(and yes, i KNOW I'll have to look deeper into Midi
some time soon )
How the heck do I tell the KPA that for example MidiCC Value 0 equals amp
gain 50% and NOT 0%? I'd really like to be able to use the full pedal way
without going over of under pre-defined limits.
Any help on this topic would be greatly appreciated.
Thx in advance.
Dannboy