Ok, I pretty much have my fCB1010 set up, but can't quite figure out how to assign a particular rig to pedal 1, another to pedal 2, etc. How exactly do I accomplish that? Any assistance would be appreciated.....
FCB1010 and rig selection question.....
-
-
What firmware doe's you FCB1010 have.
-
Uno for Kemper chip, 1.1
-
In Browse mode you need to assign a Midi assignment# to you Rigs, you can assign up to 128 midi rigs on the kemper.
Browse to a Rig then Press the System button go to page 5 Browse Mode prgChg turn nob to a Number.
-
So now on the FCB1010 Pedals 1-5 on Bank 01 are Midi assignment #s 1-5 then on Bank 02 there 6-10 and so on.
-
Thank you troynova, your posts have saved me hours of torment!