Posts by steinweiner

Quote from Burkhard

You are missing the point. Have you checked and followed my hint regarding DLY+REV Routing? This parameter sits in Rig Settings and is not included in any reverb presets. If DLY+REV Routing is for example set to +100%, it means, that the reverb in module REV only affects the wet portion of the delay in module DLY. If there is no wet portion, there is no reverb regardless which reverb preset you are loading. So the impact is huge.

Ahhh thanks for the explanation..I will check those settings and parameters..

Quote from BadBadger

Sounds like a fault, have you raised a support ticket? The unit might need to go back to Kem

Agreed

Quote from Burkhard

Instead of "dialing in" parameter by parameter, have your tried to load one of the three preinstalled Spring Reverb presets e.g. "Spring Fan"?

If this issue affects only specific Rigs and your Reverb sits in the REV module, check how DLY+REV Routing is set in Rig Settings.

Yes of course..Literally just going through each Reverb "preset" ...they all do it..None "sound" like Reverb. ALL other effects work great. I have some Pro-Studio profiles I've purchased that come with Reverb on them (..along with some other effects...) Those work great, but anything preexisting in the Kemper list of Reverb offerings have this out of phase funky sound...I tried stereo outs, speaker outs, headphones out, all do it. ONLY for Reverb.All other effects work as they should. I've owned multiple Kempers over the years, never had this issue.

Quote from nwmusic32

What is your current setup you are using for the Player? What power supply, are you using studio monitors or headphones, etc.? Something in your setup could be affecting the Kemper.

Have you tried running just the Kemper Player with the stock power supply by itself with headphones?

Also, is this happening with multiple guitars? Or just one?

Not using a Player..I have the Powerhead(toaster)..I run a 4x12 from the speaker out, and or go direct out for recording/FOH. The issue is apparent through all sound sources.

Quote from BadBadger

Are you hearing the same weirdness on all outputs (headphone out, main out, monitor out)?

Yes..In headphones, through monitor and mains...

For some reason, none of the Reverbs are working properly... I can't dial in even just a simple bit of spring reverb..it just sounds "out of phase"..like a funky bad chorusy sound..All of the reverb choices are like this, yet all of my other effects work perfectly within the Kemper... I did a master reset, still no luck.. ?

Quote from cmbrowns

It's possible to disable slots in a performance with the on/off button to the right of the slot name. In this screenshot 3 and 5 are disabled. Could it be that you have slot 5 disabled?

That fixed it! Thanks!.. Kind of weird it would do that out of the blue...The preset/profile that was in Bank 5 is gone.. No biggie..,jusy odd. ALl is good THANK YOU!!!

The #5 button works just fine in "Browser" mode, but in performance mode, it does not.. Any of my performance Banks, #5 button doesn't work.. How is this even possible? Is it possible to de-activate a button ? If so, I must have done that since the switch (and led)work on Browser mode just fine.. Also, still unable to complete a request to customer service as there is somethign wrong with the site.. Just looking for any and all help here..Thanks.

Quote from musicmad

Sorry I wasn't clear. Try turning the foot switch knob #5 and press it again.

That's what I did the first time...no luck..

I tried to fill out a form on this site, it keeps glitching ..won't send, deletes all info.. Can somebody help please? This is madnening..

Quote from musicmad

Try rotating the knob slightly and press it again. Maybe repeat. Does that change anything?

Thanks..No luck..The presets and profiles are still there..I just can't access antyhgin with button # 5..So weird. Isn't there somewhere on here to contact customer service?

Button 5 is what I should have said.. Is there a service section on this site?

All of a sudden, Bank 5 doesn't work on my controller.. doesn't ligth up or anything, all other buttons are working fine, but literally, for any and all profiles, whether in performance mode, or other, isn't even there... Didn't drop or even move it.. I've rebooted, changed out Telex connector, etc.. no luck...WTH???

I have a Powerhead, and a Boogie MKIV... There's something about the amp itslef, the "hair"..the way it pushes the cab in the room...the feel and bounce of the strings..It's truly magical..nothing like it... I profiled it , and play through my Kemper 99 % of the time...so many otions etc...roughly 90+ % of the way there complexity of the high gain (..as far as sounding and feeling the "same."..)... 100% ALL the way there for vibe and inspirational tone. Kinda hard to go spend $1000's for amp, when you've got Kemper.

Quote from OneEng1

Had to look for myself on ebay.

Sure enough, there are plenty that have gone for at or below 1K while there are still quite a few above 1K. Still, looks like selling price from on-line stores for the Rack for instance is around $1300 used.

Personally, I would recommend a used KPA to anyone at that price.

I would agree that the design is getting some years on it now. For the longest time, used units sold very close to the new price. I guess it was only a matter of time until enough used units were on the market that the used prices had to fall (that whole supply and demand thing).

I even saw a rack WITH a FC that went for $750.00. That is a crazy good deal for that fortunate soul.

While I paid ~$1700 for my rack and another $400 for my FC, I feel I have more than received my return on investment and then some. I bought mine in 2013, so I have enjoyed more than 10 years of use. I would never dream of selling though. I guess the used market is going to have to survive without my KPA :).

Display More

Agreed 100%.

None are stolen (?!?!?)... 2 are already gone from my post yesterday.. All are in excellent condition..Doesn't matter if it's 12 years old, or 1 year old, exact;lty the same hardware..ANyhoo.. A few folks are going to get a KILLER deal..wish I had extra $$..

Just an FYI...There are 5 Powerheads/toasters, and 3 unpowered racks in Los Angeles for sale on Craigslist, all othem under $1200...ugggg Makes me want to buy a back up.. There's even one for under $1K... So much for Kemper holding the value (..Powerhead still my fav of all the modeler/profilers..)

Quote from alerich

You don't make periodic backups? Really? Yikes.

I haven't backed anyhtign up since I've owned Lemper...5 years? Some day my luck will run out.

Quote from Ruefus

Its been in full release for nearly a month:

Thread

OS 10.1.2 Release

We have received solid positive feedback, that 10.1.2 solves USB connection issues. Therefor, it's our new release revision!

Rig Manager 3.4.45 for Windows(R)/macOS(R) and Rig Manager 1.4.2 for iOS(R) required!

Rig Manager 3.4.45 requires at least Windows(R) 10 or macOS(R) 10.14.

WARNING: Downgrade beyond OS 9.0.6 could lead to loss of data stored with OS 10!

Burkhard

September 26, 2023 at 12:42 PM

On it!! Not sure how I misse dthis... Im not on the forums a whole lot..I have a buddy that lives on here and usually updeates me..so much for that! Thansk!

AM I the only one who is waiting for the official release of LP? (..not Beta..) ? I don't have a thumb drive to "Back up" anything (..I've never had to use when doing updates..) and I don't record using USB, just a 1/4 guitar cable intot he front of my Presonus Audiobox into my Mac (11 year old Mac..) Loving the sounds of my profiles, but would like to experoience the "realistic" tone controls, etc... I think the fact that I'm not tech savy AT ALL, and I've already tried to do this update (..yes, update to 10 . whatever and updated the rig manager...no luck..I'm sure it's me....) I get discouraged and end up not doing the update and just palyiong my profiles.. I've watched numeroud vids on how to do it, still don't get it. Not looking for someone to explain "how to upload the beta" version, just wondering if anyone else shares this frustration and wondering when the OFFICAL LP wil be released.