Same problem on Stage.. Has anyone contacted Kemper Support previously? I just did asking this question and quoting this forum.. Just today I updated both my stage and Ampero control to confirm the issue still exits... With Hub work fine.. without a hub in between Ampero and Stage.. No midi messages are received by the Kemper.. Hopefully easy fix for them in a firmware update?
Posts by jb19259
-
-
Is there a way to route the DAW volume it's not playing to all outputs.. Currently it comes out Monitor and Master no matter what I do..
If I have a Kemper Kabinet for instance on the Monitor Output I dont want the DAW audio playing out there..
I do want the DAW audio to continue to play out the Master Output to my FRFR speakers.
Thanks,
Joe
-
I found a Stage to buy instead.. I will be looking to sell the Kemper Head and Remote soon.
-
Title says it all
I'm looking to trade my White Kemper head (non powered, Mint Condition - home use only) with Kemper Head Bag for a Kemper Stage.
Located in Truckee, CA 96161 USA
Thanks
Joe
-
+1 to the Original Topic..
Please MacOS Rig Manager over ethernet to the Kemper.. Seems nuts that I have to use the limited iOS App to use the Network connection and USB to use a PC/MacOS app
going on several years that his was1) Asked for 3 years ago.
2) Acknowledged by Kemper in June of 2021 "in any case, network support would be a good addition. we know that."
Common guys
-
The Yantan POE extender didnt work either.
I already owned a Trendnet TPE-TG44G POE switch which I have tested and does work.. but I was hoping to find something small without an external power supply... but this will work for now..
-
Earlier in this thread I made that suggestion, but Kemper are saying that it is very unlikely.
It did not work... The extender itself didn't power on. It was worth a try. After some further research I'm guessing the key looks to be Mode A (Endspan) vs Mode B (midspan)... This unit is midspan (aka Mode B) thus incompatible..
This below unit however is endspan.. So it might work. I ordered one and will report back. -
Is the Kemper 10/100 or gigabit? It looks like this passive POE/Network splitter could plausibly work (no extra power supply needed) kemper to POE splitter, 1 port to remote and 2nd port to your wifi router? Depends on how much power the Kemper can put out and how much power the remote needs..
-
Quote
However, you could try to use the Loop Mono or Loop Stereo function instead. In 5.5.2 you could place that in the DLY module. In 5.7.2 you could even place that in the REV module. Play with its Mix to balance the volume of your guitar signal versus the drum machine.
Yes this is what I did... As I said above I put a "loop mono" in the delay section and that worked.. but stil reverb was after it.. Thats cool that in 5.7.2 you can put a "loop mono" in the reverb section.. then I assume you can add the reverb in the delay spot. and you're delay in one of the two preceding spots..
I dont mess with beta, so as soon as 5.7.2 is release.. Ill install...
Thanks..
-
Can looper also record aux-in? Pretty sure the answer is no.. but just checking,..
Wanting a drum machine track to get recorded to looper as well as guitar track..
As a work around I've put a mono loop in the delay section.. and added the drum maching here (which also take the send and returns it so the guitar sounds also still work) and I can then make that work.. however.. It still runs through the reverb section (if enabled) and ideally this isnt what I want..
The reasoning behind this is that no matter how precise you tap the start and stop.. the drum machine will drift over time from the loop if it isnt part of the recorded loop.