A guitar simulator is not a bad idea though. I saw this previously in the Roland GT10 and GT100. You could make a strat pickup sound like a humbucker of vice-versa. Never did try it so I don't know how well it worked.
Posts by bdrepko
-
-
When you go through the profiling procedure. It is accomplished by sending its set of audio patterns through the amp and speakers and then analyzing the output to get the profile of the amp. The guitar is not part of this process. The only time the guitar plays any part is during the refinement of the profile.
-
Would love to have programmable delays on each of the pitch outputs on the harmonizer blocks.
-
Richard,
Just wanted to ask "how are you liking the Kemper so far"?
Regards,
Billy -
Quote from bdrepko: “I need it to go from Fender clean to full Marshall stack and back. ”
Different rigs require different switches. You can't toggle one switch for that purpose.
I was hoping anyway. Thanks.
-
I have tried searching for an answer but have had no luck so far. I have some songs where I switch quickly between rhythm and lead patches. On my AX8, you can set it up to toggle between two scenes using a single footswitch. It is way too fast to try to move my foot between different switches. Also I am not a very coordinated person. This way I can switch between clean and lead, dirty and lead, etc using on a single button.
Is there any way to toggle between two rigs on the Kemper? I cant just kick in a distortion and volume boost because I need it to go from Fender clean to full Marshall stack and back. Thanks for your help.
-
Seems like the minimum number of rigs is 5.
-
I have a 4 button midi controller. This does not mesh well with performance mode as there are currently 5 rigs per performance slot. So when I go to bank 2 on my controller, button 1 selects rig 5 instead of rig1 on performance slot2. Is there an easy way to configure performance to have only 4 rigs?
-
I have a 4 button midi controller. This does not mesh well with performance mode as there are currently 5 rigs per performance slot. So when I go to bank 2 on my controller button 1 selects rig 5 instead of rig1 on performance slot2. Is there an easy way to configure performance to have only 4 rigs?