Kemper Stompbox Mode Setup Fcb1010 (Uno)
1.Hold "Down" button and then Switch on the power button and then lit up just 8,9 and 5 button.
2.Press “Down” button to save.
Kemper Profiling Amp FCB 1010(Uno) Program Change Setup:
1.Press button (number) you want to program.
2.Hold the Down button for 3 sec.
3.Make sure only 4 & 5 buttons are lit. Unlit others.
4.Press Up button and make sure every button is off.
5.Press Up button and lit up only 1 & 6 button because we are going to program PC(1) and CC(6) messages.
6.Press 1 and it stars blinking then, enter the value of program you want to set then press Up.
7.Press 6 and it starts blinking, press Up and enter value 32 (always for Kemper) then press Up.
8.Again enter value 0 press Up and again enter value 0 then press Up.
9.Button 6 stops blinking programming complete finally press Down to save.
Kemper Fcb 1010 (Uno) Stompbox Assigning Effects:
1.Press one of the stomp button (6-10) while holding down the Down button for 3 sec.
2.Make sure all lights are turned off.
3.Hit Up and turn on only 8.
4.Hit Up again and make sure only 6 is lit up.
5.Hit 6 again and light start blinking.
6.Enter the effects CC no. and hit Up then put the value1 127 and value2 0 and hit Up.
7.Press Down button for 3 sec to save.
Kemper Fcb 1010 (Uno)Expression Pedal Setup:
1.Press Down Button for 3 sec.
2.Make sure only 4 and 5 are lit up.
3.Hit Up and make sure all lights are off.
4.Hit Up again and turn 8,9 and one of the assigned program (1-5) on.
5.Hit 8 light starts blinking than put effects CC e.g.volume for exp. pedal 1 put value1 0 and value2 127 and hit Up and then hit 9 stars blinking and put effects CC then put value1 0 and value2 127 hit Up.
6.Hold Down button to save.