Is it possible to make a selection for de Midi clock to assign to the Midi thru. Now it's only possible to assign the Midi clock to Midi out.
I use softstep to control kemper and external devices. The Kemper's Midi Out sends clock data. The Kemper Thru Sends Midi CC & Prog.C data.
So I need a Midi merger to combine Midi Out and Midi Thru to control my external devices.
Thx. JeeCee 
Thanks, looking good. Using it in browse mode???
can you share your softstep scenes???
Better use it with mac or ipad than pc
Extended memory is initialized as follows:
Switch off the board, and keep the 1 and 9 keys pressed while switching it on again.
Keep the 2 switches pressed until the display turns black. After releasing the 2 switches,
a countdown from 9 to 0 starts. After that, the board is ready to use.
Did you reflush the ram as in the description of the u4k manual???
Did you try my solution? Rig volume is post digital section so thats why this doesnt work.
Probably the digital fx section is clipping try reduce the amp block vol
Kemper has 2 programmable stereo inputs so if you buy 2 of these switches you have total of 4 buttons 
Just uploaded 4 more rigs to the Exchange have Phun!!!
Did a couple of profiles they are in the exchange. Had the same trouble with the chrunch and high gain lead tones. After http://www.bmkemperprofiles.com/ no need for the vetta II. It's like the vetta II but the tones more get a life and stand out in the mix. But can do some more profiling if you like to.
Gr. JeeCee
If u use shielded utp you have 9 pin so you can add 2 footswitches !!!
Alle andere pins sollt die aan die masse legen
Die kleinste pin is der tip
Die masse und die ring brucken
tip is signal
If they are all 3 equal impedance
16/3=5.33
8/3=2.67
4/3=1.33
1 4 ohm speaker has same impedance as 2 8ohm
so this equals in your setup 5 8ohm in parallel
thus 8 divided by 5 equals 1,6 ohm
Hi
I just downloaded "factory content 3" and "Factory content 4".Since the profiler has a lot of rigs which I am satisfied with, I dont want to import those to the profiler itself.
On the other hand, there are a lot of stomps, delays, reverbs and so…
yes put them in the shared usb and it wil load
