Posts by peterc52

peterc52 · Best power amp peterc52 February 6, 2019 at 7:42 PM

I couldnt deicide so i bought a powered (arriving tomorrow). And I have a Fryette Power Station 2 as well. Gonna compare them.

peterc52 · Weird notes!! Somethings wrong! peterc52 May 23, 2012 at 9:25 PM

It doesn't come right away when i shift over to a high gain profile, but after a couple of minutes.

peterc52 · Weird notes!! Somethings wrong! peterc52 May 23, 2012 at 9:09 PM

I do not do a two note string bend, that is the problem. It is not my hand muting the string that makes a sounds afterwards, it is just some sound it does..

I'm using monitor out into my Scarlett 2i2, and the problem has never occurred until a week ago, i haven't changed the profiles, and it does it on almost all the hi gain profiles.

peterc52 · Weird notes!! Somethings wrong! peterc52 May 23, 2012 at 8:54 PM

I have tried this a couple of times. I did a reset the last times, and it went away for an hour, now it's back.

Here is a clip:

http://soundcloud.com/peterc52/test-forkert

When I bend a higher note, for example on the 15th fret on the high e string it sounds weird!! And when i pick a note, for example the 15th fret on the high e string again, and then mute all the strings afterwards, there still a sound afterwards for a short while!

Very annoying! It only occurs on the higher notes!!

peterc52 · Won't profile -SOLVED- peterc52 April 29, 2012 at 2:27 PM

SOLVED!

I needed to play set the ground on the back of th KPA!

It works and I'm very happy!!!

peterc52 · Won't profile -SOLVED- peterc52 April 29, 2012 at 2:08 PM

Okay, so I tried again.

It turned out, that I had turned return level all the way down, so now it starts profiling my amp, but it keep coming up with another error.

It says that my amp is too noisy. Please reduce gain and repeat profiling. It is a Marshall Super Lead '77 with a master volume, so whats wrong now???

peterc52 · Won't profile -SOLVED- peterc52 April 29, 2012 at 9:00 AM

The UFO sounds did come out the through the amp for about 10 seconds before the error came. And I heard the amp in my headphones.

Wierd!

Gonna try again today.

peterc52 · Won't profile -SOLVED- peterc52 April 28, 2012 at 1:41 PM

Hi guys,

Just got my Kemper yesterday and I'm happy so fare, but...

When I tried to profile my Super Lead '77 it kept reporting an error. It said that either the volume was to low or that a reference amp was not connected.

I connected the amp like this:

Guitar into KPA input.
Direct output/send to amp input
Mic (SM57) into KPA return

Headphones to KPA headphone

I was fairly loud in the room.

What is wrong?

peterc52

Editor.

No betas.

And then I just hope that Kemper will keep on developing on this amazing little unit!

peterc52 · Best higain profiles? peterc52 April 27, 2012 at 11:35 PM

I just recieved my Kemper today and there is A LOT of profiles!

So I ask you, which ones are your favorite higain profiles?

/Peter from Denmark