Thanks so much guys! Seems like I'm going to give it a go. Great help, much appreciated!!
Posts by JP86222
-
-
Hey guys,
I've been playing Kemper for almost ten years, mainly a Stage for the last 4-5 years, both studio and live, and it's all I'll ever need. However for some fly gigs or remote studio sessions it would be ideal if I could use a Player and bring my tones in an even smaller package. But before I buy one to try things out, only to have to return it and condemning it to a B-stock item, I'd like to ask you guys if the following setup is possible with the Player.
My rigs aren't really all that complex I think; on the Stage I basically only use one Performance with a clean rig, a drive rig and a lead rig. I use morph on all of these three rigs, only for a 3 dB boost in output level (amp volume parameter) for solo's. I use a spring reverb on all three rigs and a tremolo and chorus on the clean and drive rigs. I have a delay programmed on all three rigs but rarely use it tbh so I could part with that on the Player.
Now, could I replicate this on the Player? After spitting through the manual I can understand that I can add the three rigs to the first bank, but would it be possible to engage and disengage the tremolo and chorus on the clean and drive rigs with only three foot switches, while also maintaining the 3 dB morph boost for each rig and the ability to quickly navigate through rigs mid-song? Some songs require all thee rigs plus effect switching. Any help would be very much appreciated; I can also completely understand if this is not possible on such a compact device, but it would be great if I could get it to work without having to make a dozen rigs spread through multiple banks.
Thanks guys!
-
Thanks for the reply. Yes, I’m absolutely sure — I only turn it off using the power button.
Okay. I think you will need to contact support to get it fixed.
-
Hope you get adequate volume. Even with boost I couldn't get the fender loud enough even for rehearsal. Got rid of it thanks to guitar center return policy.
Either you rehearse at insanely loud levels, or something went wrong. The FR12 can go crazy loud. Are you sure you fed it a loud enough signal?
-
I think this is normal behavior. If the unit is on and isn’t powered off before detaching the power cable, next time power is connected, it will boot without pressing the power button.
Are you sure you’ve powered it off before unplugging the power cable?
-
You can also use the Amp Volume parameter in the Amp block for this. You can set it to Morph up a few dB. This way you don’t have to use an effect block just for clean boosting.
