Posts by Loafman3

I decided to try to re amp today, 2 hrs later,

I read the manual, watched a few videos and spoke to Kemper guy

Here is signal chain, Focusrite 2i2 ( No SPIDF), Pro Tools , Mac

Gtr - Input front of Kemper

Direct Output on Kemper to FR Input 1 ( Direct output set to GIT Studio)

Main output kemperBack Left - FR Input 2 ( Main output assigned to Master Mono, or stereo or left or right )

Line output 1 Left on FR to Return input on Back of Kemper

I set two tracks in pro tools, both mono, One for input 1( Should be dry), one for Input 2 ( Should be amped). Outputs on both tracks is Out 1-2

Listening with headphones on scarlet

Track one has dry signal

Track 2 has nothing

If I enable

1 and two on DAW , feedback in 2

Kemper headphones work

Cannot get the signal back into the Kemper, I checked with a speaker and there is a signal going in

If I change input source to front, I can record, dry and amped. Not With input on

Something to do with routing in pro tools? I bet all this goes away if I get SPIDF

Any ideas, been running pro tools over 10 yrs, and I am puzzled

I did the big pack tonight. Everything I tried was balanced nice and sits well with a superior drummer track looping
will have to get out the acoustic tomorrow.

There are a lot of nice profiles in there. You did a really nice job.

Anyone went through the Morgan pack yet.

Picked up the apex, mark IV and fried 50. I haven’t even really sunk my teeth into the 2nd two. The apex has a high percentage of excellent profiles. My gosh.

I must say. I got the BM2 last night.
tried with my carvin with split and push pull. I am getting some tremendous tones. I mean holy tones Batman