Maybe the Kemper Profiler Switch would be an alternative. But I've never tried it myself.
Posts by 9084cb6f0ec61c82220f28f27dd834db1b02c280
-
-
When switching from a Rig with Acoustic Simulator (amp and cap section are disabled) to a "normal" Rig with gain the output LED lights up red for a short time.
My Workaround now is: reduce amp volume (e.g. - 5db) and increase rig volume (+5 db). This solves the issue.
But is this the right way? Maybe someone has a better solution.
-
-
From looking inside the rack there is a lot of spare room. I guess the size was dictated by the front panel and screen...
Maybe a touch screen could help to save space, since the front panel could be scaled down by omitting some hardware buttons.
-
-
-
-
-
Maybe someone knows a profile of a Rennsau Amp?
-
-
-
Quote
Basically when you play with a metronome or a drum machine, it soon becomes dismayingly obvious your Remote loop is at least a few ms out of sync.
+1 for quantization
Preferably in combination with an integrated metronome, presumably to simplify the synchronization:
starting looper and metronome simultaneously with one button, where the beat should be counted up for one tact before recording.
-
-
-
Quote
...the monitor cab on/off status on a per rig basis (thus enabling imprints vs FR) and this is not possible.
Yes, in my opinion a must have. It is a major limitation when the original cabs can no longer be selected.
-
Now, you have to press two different buttons on remote - first switch to new performance (up button), second enable morph of first rig (rig button).
For me it would be a simplification:
Play song 1 with performance 1 and then song 2 with performance 2 without a break, whereby only one button would have to be pressed on remote (up button).
So, you have to think less about the right setup and you can concentrate more on playing.
-
-
-
-
For example, I use morphing to switch to more gain, bass etc. while playing a solo or a refrain.
Usually a song starts with a verse (calm part, non morph) and later I switch to the other part. It works fine!
But sometimes a song starts with a solo. By choosing this performance per remote I always have to think about changing to morph mode, too.
Yes, in this performance I can turn it around (non-morph = lead, morph = verse). But its very confusing and it is hard to think about it every time.