Is there no way to adjust the curve for the volume pedal? Mine is connected via a midi controller, sends out a nice linear range from 0-127, but the resulting volume control (pre efx) is just too abrupt in the beginning of the curve. As if it goes on/off around 10. I really would like a smoother transition, if possible....
Adjust curve for volume pedal?
-
Trazan -
May 16, 2013 at 2:09 PM -
Closed -
Thread is marked as Resolved.
-
-
What you're looking for is a logarithmic curve -
in an analog expression pedal there's a potentiometer that you can replace to get a "logarithmic" response - in a MIDI controller, there should be an internal setting to set the pedal from linear to logarithmic. -
What you're looking for is a logarithmic curve -
in an analog expression pedal there's a potentiometer that you can replace to get a "logarithmic" response - in a MIDI controller, there should be an internal setting to set the pedal from linear to logarithmic.
I'd think the midi values (resolution) sent should be linear....and I can't change that on the All Access anyway. I need to be able to adjust the response curve on the Kemper. No go? -
The resolution can be converted at any point along the way - so yes, even in the KPA.
It's not commonly done this way though, so i wouldn't get my hopes up. -
I have reported the this problem several times here ( 1 , 2 ), especially the abrupt beginning of fades. But the response from Kemper is not quite suitable to arouse hopes too much. However, you never know. And in the long run you can be certain that this problem will be dealt with in some future FW.
-
there are now known whether it will be possible in the KPA, when connecting a Mid Volume pedal select several of volume curves (non-linear).
(I have the FCB1010 Although the Uno4Kemper but not the version 1.2).gibt es inzwischen Erkenntnisse, ob es im KPA die Möglichkeit geben wird, beim Anschluß eines Mid Volume Pedals mehere Volumen Curven auszuwählen (nicht linear).
(Ich habe im FCB1010 zwar den Uno4Kemper aber nicht die Version 1.2).Grüße Micha
-
Is there no way to adjust the curve for the volume pedal? Mine is connected via a midi controller, sends out a nice linear range from 0-127, but the resulting volume control (pre efx) is just too abrupt in the beginning of the curve. As if it goes on/off around 10. I really would like a smoother transition, if possible....
The volume pedal expects linear values from the expression pedal and applies these to a perfect logarithmic curve.
I wonder why many assume here that it works by a linear curve.The first midi value 1 creates an attenuation of -84 dB, value 2 does -72.
That is a very smooth start of the curve.If it starts so abrupt with your device, please check if the lower value range is really as linear as you describe.
A non-continuous curve from an expression pedal can never be compensated to satisfaction by an adjustable curve.