When Running to a Power Amp and Real Cab

    The Profiler Model referred to in this thread is ...
    ☑️ Profiler Stage

    Newbie question again..

    only at practice, I need to run into my power amp and 4x12 cab. I’ve read to use the “monitor out” outputs for this, and to turn off the cab sims section.

    However when I do this, it seems to turn it off on my main outputs too, unless I am reading something wrong on the display. Is this something I am just going to have to remember to turn off and then back on when I run direct?

    Also struggling with my expression pedal, it’s a Headrush, with a toe switch, it works fine as volume, OR a wah. I only have wah on one or two rigs within my performance, and I want it to work as a volume on the rigs without a wah, is this possible?

    Quote from PaWieB

    However when I do this, it seems to turn it off on my main outputs too, unless I am reading something wrong on the display. Is this something I am just going to have to remember to turn off and then back on when I run direct?

    Don't bypass the cabinet module. This will remove the cabinet in (all) outputs.


    In order to remove the cabinet for Monitor Output, and keep it for Main Output, there is an option at Monitor Output called "Monitor Cab Off".

    Edited once, last by Casuso: typo (July 31, 2026 at 8:58 AM).