SOLVED - Kemper Rack & Remote: Exp Pedal Wah-Volume Issues

I know this has been covered many times, and is in the manual and in videos, and I reviewed all of them and I'm stumped. For starters:

1) Kemper Rack running OS 13.0.2
2) Kemper Remote
3) Mission EP1

My Wah/volume used to work and for some reason is not now. I don't know that I've changed anything, but I have updated the OS a couple times and I don't use the wah much, so I just recently noticed it wasn't working. Here's the set up:

1) TRS from EP1 plug 1 to Remote plug 5 (I marked plug 1 when I got the pedal so I would never confuse the two).
2) TR from EP1 plug 2 to Remote plug 6
3) On Rack System Page:
a) Pedal Links: WahPedal > Volume is checked
b) Pedals 1-4 not connected
c) Pedal 5: Mode = Pedal Type 1; Function = Wah Pedal; calibration works and done
d) Pedal 6: Mode = Mono Switch; Switch Tip = A On/Off
4) Stomp A is locked as Wah, type is "Cry"; Pedal Mode is ON; Mix is 100%; Vol = 0

The EP1 toe switch turns the Wah in Stomp A on and off. When off the EP1 works as a volume pedal per my settings. When toe switch turns the Wah in Stomp A on, there is no wah effect. Same on all rigs (the Stomp A is locked and is wah in all rigs).

I've tried different cables, although since the toe switch turns the wah on and off, and the volume works, the pedal seems fine. I have a 2nd EP1 and tried it just to be sure, and same result as the first.

It seems like I've got a rig setting or stomp setting buggered where teh wah turns on but doesn't do anything.

I appreciate any thoughts ... this is driving me crazy.

Greg

I'm a moron. I had somehow hit the stomps button on the Rack and disabled the stomps section. Clicked it on and all is good.

Good grief ... there's just no substitute for pilot error.