Switching another amp with midi.

    • New
    The Profiler Model referred to in this thread is ...
    ☑️ Profiler Head/Rack

    I have a Profiler Rack Kemper and tried connecting it to my Marshall JVM 410h via Midi out from Kemper into Midi in, on the Marshall.

    On the Kemper I went to system and paged over to telling Kemper that channel 1 is Midi out.

    Nothing happend, the Marshall would not move when I switched my control channels on the kemper control pedal.

    I even connect another midi cable from Marshal Midi out to Kemper midi and with both cables connected I still couldn't get the Marshall to move with the Kemper.

    Does anyone know how to control another amp switching it with the Kemper via Midi command?

    • New

    From the manual:


    Transmitting MIDI Commands to Two External Devices in Performance Mode

    MIDI commands can be triggered and transmitted to external devices (maximum 2), whenever a Slot gets loaded in Performance Mode.

    You can, for instance, use this to switch presets of external effects devices that are connected to the effect loop of the PROFILER.(or also switch your amp channels)

    Global setup:

    • In System Settings, navigate to “Performance Mode: MIDI” page. Please note that this page is only accessible in Performance Mode.

    • Use the soft knobs to assign a MIDI channel to each of the external devices. (You´ve done this, I assume)

    • Use soft buttons to determine whether the corresponding external devices are connected to MIDI OUT or MIDI THRU. The MIDI THRU is not available at PROFILER Stage.

    • For your convenience, you can also assign meaningful names to the two external devices “A” and “B” using soft buttons.

    Performance setup:

    • Press “Edit”, “Slot Settings”, and “MIDI Settings”.

    • Select “PrgChg” and number per device, as intended.

    • Repeat this process for every Slot and Performance you plan to send MIDI commands from.

    ✓As soon as you select MIDI THRU to transmit MIDI commands by Slot the PROFILER will stop forwarding incoming MIDI data to the MIDI THRU.