Amp volume CC without pedal volume

1st Official Post
    • New
    The Profiler Model referred to in this thread is ...
    ☑️ Profiler Head/Rack

    Hello!


    Hope you're good!

    I'm using my kemper with my Morningstar MC8 and I want to know what is the CC to control the Amp Volume Knob.

    I'd like to assign a value that can give me +3db to this knob


    Thank you so much!

    • New
    Quote from PauRomero

    I'm using my kemper with my Morningstar MC8 and I want to know what is the CC to control the Amp Volume Knob.

    I'd like to assign a value that can give me +3db to this knob

    You'd first need to know the current value in order to add 3dB to the value.

    You could set it to +3dB but depending on what it is saved at may result in a different amount of level change

    alternatively, you could use your amp volume to "level out" between rigs and then keep your rig-volume at a default of 0dB then command this rig volume to +3dB in order to always get a 3db change.

    check out this article for something similar i done to achieve a "3dB solo boost" for any preset-

    Post

    RE: USB MIDI

    […]

    for the Kemper, just send four CC messages in your arduino (often easier than attempting to implement NRPN which i dont see much of in the arduino midi-libraries. You can find the values in the Kemper midi-spec without having to calculate the actual NRPN, (which if i recall from memory is MSB*128 + LSB.

    I have an "older" list that covers most NRPN values, page 3, here https://greendog.co.uk/kemper/kemper-midi-data.pdf You can get the MSB and the LSB. Just need to work out the parameter…
    slateboy
    May 12, 2024 at 2:53 PM