profiling amplifier don't close reverb
no volume after close reverb
all tone hvee a lot of reverbenration
Pls help me! TKS
profiling amplifier don't close reverb
no volume after close reverb
all tone hvee a lot of reverbenration
Pls help me! TKS
profiling amplifier don't close reverb
No volume after close reverb
all tone have reverb...new perfrom too
pls help~~~thanks
Check you Output settings, look like is set to DLY/REV Wet, it needs to be Master Stereo (or Master Mono if you use only the Left channel)
Check the other answer I gave you. Sounds like your Ouput is set to DLY/REV Wet, it needs to be set to Master Stereo
I'm not sure I understand what you are saying but it sounds like you are getting only reverb and not dry amp signal . If I have understood the problem correctly there is an simple answer fortunately.
Go to Output Menu.
For the Output you are using (main out, monitor out etc) look at the settings for Output Source. I suspect that yours is set to Dly/Rev. If so change it to Master Stereo or Master Mono. Everything should be fine after that 👍
Edit - Kellerblues answered while I was still typing 😎
no double posting please
Sorry, answered from the notification tab
I'm not sure I understand what you are saying but it sounds like you are getting only reverb and not dry amp signal . If I have understood the problem correctly there is an simple answer fortunately.
Go to Output Menu.
For the Output you are using (main out, monitor out etc) look at the settings for Output Source. I suspect that yours is set to Dly/Rev. If so change it to Master Stereo or Master Mono. Everything should be fine after that 👍
Edit - Kellerblues answered while I was still typing 😎
thanks Resolved