Quiet Profile into DAW

scottglasson1 · June 19, 2022 at 6:39 AM

What is my best way to boost a quiet profile output without having to re-adjust everything when I go back to a profile with a more normal output? TIV

Finally · June 19, 2022 at 7:51 AM

I would just turn up the volume on that rig and save it, so you always have it available.

BayouTexan · June 19, 2022 at 5:14 PM

Rig Volume parameter - set it and forget it.

scottglasson1 · June 20, 2022 at 12:21 AM

Thanks to all who replied.

harmonik · June 20, 2022 at 7:09 AM

I always seem to end up using a combination of rig volume and amp volume. I have a phobia turning either one up over 4db..

Dynochrome · June 20, 2022 at 7:31 PM

Amp volume is what is suggested in the manual to even out profile volumes. I've never had to go more than 3.5 DB and if I did, I would consider the profile too substandard to use. I leave rig volume at noon always and morph rig volume for solos. Everything is adjusted using amp volume to get it where I want it. They are adjusted and saved in the browser section. My browser contains everything I would possibly use. That way no matter what I drop into a performance, it's pretty much ready to go mix wise and matches everything else.