I attached a video.
You can see the remote after the boot of the profiler head (newest official OS).
The remote does not boot until finish, it stays in a situation in which one button is blinking red.
Then I push that button and the remote finishes booting.
If I don't push the button, the remote will stay in this blinking situation and will not boot until the end.
Does anybody know what is the problem of the remote?
Are you using the original cable?
Have your tried another cable? Either the original or a short standard Ethernet-cable ....
Hello.
Yes, it is the original cable.
I didn't try another cable because the Ethernet cables, I have, are longer than the original Kemper cable.
What is the problem of the Remote? Doesn't it get enough power? But if so, if I hit the button the remote boots correctly.
So I don't understand why the cable could be the problem. After pushing the button, the Remote works fine with the connected cable.
to be honest , until I got my Stage, 2 yrs ago, I hadn’t used the stock cable for at least 5-6 yrs
I rarely had any kind of issue
to be honest , until I got my Stage, 2 yrs ago, I hadn’t used the stock cable for at least 5-6 yrs
I rarely had any kind of issue
That means: In your mind the issue is not caused by the cable?
