Stomp status being saved on Rigs in performance mode (bug?)

    Hello all,

    Just upgraded to latest non-beta release 7.5.4 (previously on 7.4.something).

    On my unit the stomp statuses are now persisted in performance mode.

    Example: slot 1 - crunch stack with a TS in stomp 1, default off

    If I turn on the TS in slot 1 (using Kemper remote), then switch to another slot in the same performance, then switch back to slot 1, the rig is loaded with the TS on.

    If I turn on the TS in slot 1, then switch to another slot in a different performance, and then switch back to slot 1, the rig is loaded with the default setting - TS off.

    Going to guess this is not by design - can anyone reproduce?

    Thx in advance!

    M.

    Hi asmosmax.

    If you have RigManager running and connected, this behaviour is by design.

    This allows you to make temporary changes within a Performance that are retained as you move between Slots within the Performance. Those temporary changes are retained until you switch Performances.

    ST

    The manual describes intended behavior in its chapter "Performance Mode":

    • While navigating Slots within a Performance via the PAGE buttons of the PROFILER Stage, or the left and right RIG navigation cross buttons of the other PROFILER variants, any modifications (e.g. loading another Rig, or cranking up Gain) are interpreted as editing, and will be retained until you move to another Performance. Don’t forget to store before you load another Performance, if you want to make those modifications permanent.
    • As soon as you load another Slot from your foot controller, or foot buttons of the PROFILER Remote or Stage, any former modifications within that Performance are interpreted as temporary tweaks during a live performance and will be discarded immediately. If, for example, you had activated a booster in module B, or increased Delay Mix via pedal, any such changes will be lost if you switch Slots remotely. This way, you can always be sure that Slots will be loaded in their original, predictable state during live performances.
    • However, there is an exception to this practice: While Rig Manager is connected, any modifications are interpreted as editing and maintained during Slot changes as long as you stay within the same Performance.