Remote lights on switches...

GTARPLR · October 15, 2018 at 9:09 PM

I noticed that when I watch any tutorials from Kemper that have the remote, all the lights on the buttons 1-8 are off EXCEPT for the one that's actually activated.

On mine, I see all the lights 1-8 are partially on, then the green light glows brighter for the one that's actually on. It's only a slightly brighter amount. I would like to have the lights 1-8 to be all off except for the one that's supposed to be on, or the Morphed channel.

I've gone into the setting of the remove on the Kemper for the remote, but I'm unable to achieve what I'm looking for.

Any ideas?

Burkhard · October 16, 2018 at 9:31 AM

Difference between Browser Mode and Performance Mode.

Wheresthedug · October 16, 2018 at 9:50 AM

Quote from Burkhard

Difference between Browser Mode and Performance Mode.

i have never looked into this. Are you saying that all should be OFF in Browser mode but all slots in use in a performance have a faint glow to show they in use but not selected? That makes a lot of sense.

Burkhard · October 17, 2018 at 10:18 AM

In Performance Mode the enabled Slots of the Performance currently loaded are indicated by dimmed lower LEDs. The Slot currently loaded is indicated by a bright lower LED. If any lower LED is off, then the corresponding Slot is disabled as it cannot be loaded remotely.

Browser Mode only indicates the Rig currently loaded by a bright lower LED.

Wheresthedug · October 17, 2018 at 10:36 AM

That makes a lot of sense and is another example of the KPA /Remote integrating seamlessly in the real word. thanks Burkhard