Morphing problem (using Kemper remote) with effects, and without...assistance please...

GTARPLR · October 15, 2018 at 9:03 PM

Finally got my Kemper sounding good and getting my rigs set up. I'm using the Kemper remote and have the rise and fall times set to zero because I need instant change.

I would like the bottom half to be a crunch "dry" setting. I have my Morphed "B" side with more gain and more volume...no problem.

But when I Morph to the upper half of the same channel, I'm finding that I can't add Delay or Chorus, or anything for that Morphed side only, it affects both A and B sides.

I want to have the dry channel to be on the A side, and the B side (Morphed) to have more gain and volume PLUS a delay, and Chorus for the B side. Then go back to A and have the dry signal again.

So far, everything I try put the effects on both side. Can this be done?

Cheers and thanks.

Kemper Support #1 · October 15, 2018 at 9:34 PM

you need to morph the mix parameter for each effect to achieve what you are after

GTARPLR · October 15, 2018 at 9:55 PM

At this moment, I'm trying to imagine how that's done.

Can you provide details?

Kemper Support #1 · October 15, 2018 at 10:01 PM

morphing the mix parameter in an effect works just like morphing any other parameter. Set it to zero /all dry in the A position and to the desired mix value at the B position. Repeat this for every effect that you want to use in a rig.

MuddySludge · October 15, 2018 at 10:19 PM

For "Instant Change" how about a second performance with all the setting you can jump right into?

djdyer · October 15, 2018 at 10:28 PM

Morphing can not be used to turn on effects. But it can be used to turn change the parameters from zero effect to the effect level you want in the morphed version. For example, a pure boost from zero db to + 2db to add some drive for a lead.

GTARPLR · October 15, 2018 at 11:12 PM

I have on position #1 ("A"side) a delay effect set to Zero so there's nothing on it, just a dry rhythm tone, and I have that exact same settings for the "B" Morphed side with the delay on and it's set at 35% for the "B" morphed side. That's all fine. I go from dry to boost with delay on position 1...all good with that.

But...

My #2 switch already is designated for a solo boost, with more gain and volume, PLUS a bit of delay with chorus on it, which is totally separate settings than on #1. The delay settings are longer. If I go to the Morphed side of the same #2 switch, can I change the delay or chorus to be a totally different type without affecting the original "A" settings of #2?

Burkhard · October 16, 2018 at 9:29 AM

You cannot morph an effect type as such as this isn't a continuous parameter. However, you could arrange two delays within the same Rig e. g. in Module MOD and DLY and then morph the Mix parameter of both. Base Sound: Mix in MOD is 60% and Mix in DLY is 0%. Morph Sound: Mix in Mid is 0% and Mix in DLY is 55%.