Volume Problems after FW Update

fourstrk · May 15, 2017 at 12:44 PM

After updating the KPA to the newest FW version I have huge problems with volume levels. All the volumes of the clean profiles are way too low while all of the distorted profiles have the same volume as before. Even when I turn the volume knob (NOT Master Volume) all the way up, it is not enough. I did not modify Clean Sens.

Clean Sens = 6.8
Dist. Sens = 0.0
(Low Output Strat PUs)

Do you have any ideas what I could have done wrong? I need it live tomorrow and though that updating would be okay, but ...

SgtPepper · May 17, 2017 at 10:32 AM

Here is an idea...
Initialize the global settings.
Fyi: Although my descriptor says "Beginner " I am anything but that.
So give that a whirl.

fourstrk · May 17, 2017 at 10:37 AM

I'm a beginner too!

I did 2 or 3 reboots and the problem was gone ... no idea what it was but it never happened again ... now it's a myth because nobody else could observe it.

SgtPepper · May 18, 2017 at 5:14 AM

Yeah that's a common response in these here Kemper discussions. It's called bad initialization procedures or something is randomly overwriting parameter locations used in the audio processing blocks. Both are not very nice.